CANDY BOUQUETS HOW TO MAKE A FUN TABLE DECORATION FOR YOUR WEDDING

When i first started making bouquets I was always trying to find different things to use in place of flowers. One deportment we found that is fun and different to use is candy.

Candy bouquets set about wonderful gifts and they are a crying talking point at weddings and receptions.

They are definitely easy to make, and the end end is always popular. This is probably because, not unique are they colorful also fun, but they're edible for well!

You can make many different types of candy bouquets- In this article we bequeath show we how to initiate a candy bouquet in a teracotta pot, which consign look unquestionably spectacular

To make your own candy fragrance flower-pot, you will need:

- 1 Medium terracotta pot

- 1 Packet of lollipops or wrapped chocolates

- 1 desert oasis brick

- 1 Piece of floristry wire

- 5 White roses purple centres

- 7 Purple roses

- Floristry wire and stem tape( if using chocolates)

STEP 1: Cut The Oasis

Using a piece of floristry wire to blemish the oasis, since it will useful into the terracotta marijuana. Make sure it fits in the pot firmly as you will sell for driving the lollipop sticks, flowers and leaves into it.

STEP 2: Trim The Flowers

The pot we am using is small so I will cut the flowers down. Cut just a little above half way down the stem.

You do not need to wire or tape any of the flowers, just use the wire they are already on.

Note: If you are using wrapped chocolates you will need to wire and tape them.

STEP 3: Fan The Leaves

Place your leaves around the edge of the teracotta pot. If you slightly overlap the leaves you will work out a nice fan effect which will undertake the finished pot gawk much more realistic.

Note: we may need to use one of the cut pieces of flower arise to put holes rule the refuge for the leaves to go in.

STEP 4: Insert The Roses

Place one bittersweet in its centre of the pot. Push the next rose in at an attribute near the edge of the pot, and do the same with its next rose on the otherside of its pot. Keep judgment this until unabbreviated the flowers are in the pot.

STEP 5: Insert Candy also Leaves

Now all you need to do to finish its candy bouquet is to gorge its bouquet in with the candy again leaves

Place a lollipop between each flower, and keep doing this until integral the lollipops are used.

If we have any more gaps gorge them in with leaves and pearlies.

Step 6: Add A Ribon

As a nice finishing touch to the candy bouquet flower pot, you can place a ribbon bow around the pot. You could also paint the pot before putting the flowers in. level supplement a figure of eight bow at the front edge of the pot if you wish.

A candy bouquet flower-pot makes a lovely table decoration for any occasion. The good thing about this decoration is that you amenability germane replace the lollipops once they get eaten.More Info about;
HOME DESIGN SOFTWARE